C
M
HIP
ATERIAL
Feeding Tips
•
If feeding material by hand, always feed from the side of the infeed chute; never
directly behind it.
•
Feed large end of log or branch into chipper first.
•
To stay out of traffic while operating along a road, feed material from the curbside.
•
If feeding brushy material that frequently catches on Lower Feed Stop Bar and stops
the feed rollers, change sensitivity setting to REDUCED SENSITIVITY. (BC1200XL
only)
•
Sometimes during feeding, a limb will suddenly turn or move sideways and may strike
you. To reduce the possibility of being struck, release the limb immediately after it
begins feeding and then turn away.
Material Size
•
The brush chipper will chip logs approximately 12" (30 cm) in diameter.
•
Sometimes a log, due to its size and shape, will not go in. Trim or shorten the log to aid feeding it into the
chipper.
BC1200XL Brush Chipper
WARNING: Check material being chipped. Avoid stones, wire, or other objects
which may damage the knives and become dangerous projectiles.
Operating the Brush Chipper 50-11