Plugs or Stalls
•
Discharge chute, cutter drum, or feed roller may become plugged during operation. Refer to
from the Brush Chipper, page 51-1.
•
If the engine stalls while chipping, disengage cutter drum before restarting engine.
•
Start engine and, before engaging cutter drum, reverse feed rollers to remove the material that caused the
stall.
Finishing
•
Chipped material that accumulates in the infeed chute can be pulled into the machine by feeding in
a piece of brush, or by pushing it in with a long limb. Never push chipped material with hands,
feet, rake, shovel, or any other object.
•
Shut down machine when the chipping operation is complete. Follow
1.
50-12 Operating the Brush Chipper
Removing Plugs
Shutdown Procedure,
page
23-
BC1200XL Brush Chipper