Vermeer BC1200XL Operator's Manual page 41

(3)
Winch Engage/Disengage Lever
Rotate lever up . . . . . . . . . . . . . . . . . . . . . . . . . . . . winch ENGAGED
Rotate lever down . . . . . . . . . . . . . . . . . . . . . .winch DISENGAGED
Allows winch line to be manually pulled off winch drum.
IMPORTANT: Winch Engage/Disengage Lever must fully lock into ENGAGED
position in order to perform forward and reverse operation. If lever does not lock into
the ENGAGED position, jog Retract/Extend Lever (4) until it does.
(4)
Winch Retract/Extend Lever - With winch engaged:
Left . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . retract winch line
Right . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . extend winch line
IMPORTANT: Maintain light tension on winch line when retracting,
to create smooth wrapping onto winch drum.
Rear Warning Light - Side
(5)
Amber lights are located on both sides of winch mounting frame.
Normal sensitivity setting selected. . . . . . . . . . . . . warning light off
Reduced sensitivity setting selected . . . . . . . . . . . . warning light on
Light flashes quickly when feed rollers need to be restarted after pressing Lower
Feed Stop Bar, or pulling Upper Feed Control Bar.
NOTE: When the Rear Warning Light flashes quickly, the Hold-to-Run Button must
be pushed to reset stop system and stop warning light from flashing.
BC1200XL Brush Chipper
5
3
4
Controls 20-19