Operating The Brush Chipper; Cutter Shaft - Check; Cutter Drum - Engage - Vermeer BC1200XL Operator's Manual

Section 50: Operating the Brush Chipper
C S - C
UTTER HAFT
Start engine. Refer to Starting Procedure, page 22-1.
to see that the cutter drum does not turn while the Cutter Engage/Throttle Lever is in
the DISENGAGED/LOW RPM position. If rotation occurs, adjustment is necessary.
Refer to the Maintenance Manual, 50 Service Hours
C D - E
UTTER RUM NGAGE
After engine has warmed up, grip Cutter Engage/
Throttle Lever (1) firmly and move it slowly to the
ENGAGED/HIGH RPM position.
BC1200XL Brush Chipper
HECK
Check cutter drum shaft end (1)
section for instructions.
1
LEFT SIDE CONTROLS (OPTION)
1

Operating the Brush Chipper 50-1

1