Feed Table; Feed Control Bars - Check - Vermeer BC1200XL Operator's Manual

Feed Table

Unlatch feed table and lower to operating position. The feed table provides
an important measure of safety by increasing the distance between the feed
roller (1) (behind curtain) and the operator. Never operate brush chipper
with the feed table removed.

Feed Control Bars - Check

The brush chipper is equipped with an Upper Feed Control Bar (2) located
across the top and sides of the feed table, and a Lower Feed Stop Bar (3)
along the bottom of the feed table; also Side Feed Stop Bars along both sides
(4) of the BC1200XL European. Do not operate brush chipper unless the
control bars are installed and operating properly. Refer to
Controls, page 20-6.
BC1200XL Brush Chipper
BC1200XL
Feed Roller
3
BC1200XL
European
3
Preparing the Brush Chipper and Work Area 40-9
2
1
2
1
4