Vermeer BC1200XL Operator's Manual page 93

Step 6: Use Winch Retract/Extend Lever (4) to
retract winch line and pull limb toward
feed table. (Winch is designed to
operate at full engine speed.)
IMPORTANT: Do not move Winch Engage/
Disengage Lever (1) while winch line is under
load. Limb on end of line may roll or fall back
toward other workers.
Step 7: Continue pulling limb forward until
front of limb rests on feed table.
WARNING: Unstable limb may fall off feed table. Serious injury may occur if struck. Stabilize limb on
feed table before repositioning chain.
Step 8: Use Winch Retract/Extend Lever (4) to extend winch line to allow chain choker to slacken.
Step 9: Remove winch line from choker and reposition choker farther back on limb. Further extend winch line
and re-attach loop to end of choker.
BC1200XL Brush Chipper
1
4
LEFT SIDE CONTROLS (OPTION)
Operating the Brush Chipper 50-21