Vermeer BC1200XL Operator's Manual page 78

IMPORTANT: When Hold-to-Run Button is released:
• Feed rollers stop if either bar is in the STOP position.
• Feed rollers run if both bars are in the RUN position.
If material continues to strike the bar and stop the feed roller, trim or shorten material before
feeding it into the chipper.
NOTE: Each time the engine key is turned ON, the rear warning lights (3) flash quickly, and
Hold-to-Run Button (2) must be pushed to start feed rollers.
NOTE: Engine throttle must be set at HIGH RPM before feed rollers will start.
50-6 Operating the Brush Chipper
3
2
LEFT SIDE CONTROLS (OPTION)
SHOWN
BC1200XL Brush Chipper