Configuring Communications; Setting The Projector Communication - Christie HS Series User Manual

Configuring
communications
Define and control how single or multiple projectors are linked with each other and with controlling
device.

Setting the projector communication

Enable the receivers and the wired keypad to communicate with the projector from the remote. The
front and top IR sensors receive transmissions from the IR remote. Keep the transmission path to
these sensors unobstructed for uninterrupted communications with the projector.
1. Select Menu > Configuration > IR Control.
2. To enable the front IR sensor, check Front.
3. To confirm the selection, press ENTER.
4. To enable the top IR sensor, check Top.
5. To confirm the selection, press ENTER.
6. To enable the signal from the HDBaseT Box, check HDBaseT.
7. To confirm the selection, press ENTER.
8. To set the projector address, select Menu > Configuration > Communications > Projector
Address.
9. Select specific number for this projector from 0 to 9. The projector responds to the IR remote
set to the same address as the projector or to the IR remote set to address 0.
10. To match up with the projector address, press PROJ and specific number key.
HS Series D16-20 User Manual
020-001466-01 Rev. 1 (10-2018)
Copyright ©2018 Christie Digital Systems USA Inc. All rights reserved.
52