Table 2: Waveform Sweep (Horizontal) Deflection; Table 3: Component Vector Mode; Table 4: Waveform Mode Filter Characteristics - Tektronix WFM5200 Technical Reference

Table 2: Waveform sweep (horizontal) deflection
Characteristic
Accuracy
Sweep
Linearity
Timing Cursor Delta Readout
Accuracy, Typical
Rates
Line Select

Table 3: Component vector mode

Characteristic
Vertical SD
Bandwidth,
HD
Typical
Vertical Gain Accuracy
Horizontal Gain Accuracy
Display to Graticule Registration
Vector Display
Luma Qualified Vector Threshold
Accuracy
Table 4: Waveform mode filter characteristics
Characteristic
Low Pass SD,
Filter Gain component
only
HD,
component
only
Low Pass
SD,
Filter component
Frequency only
Response
HD,
component
only
WFM5200 Waveform Monitor Specifications and Performance Verification
Performance requirement
± 0.5%, all rates
0.2% of time displayed on screen
Performance requirement
± 0.5%
± 0.5%
± 0.5%
± 1%
Performance requirement
≤ 3 dB attenuation at 800 kHz
≥ 32 dB attenuation at 3 MHz
Filter meets IEEE STD-205
≤ 3 dB attenuation at 4.5 MHz
≥ 25 dB attenuation above 15 MHz, Noise
bandwidth is approximately 8 MHz Stopband
null at 18 MHz
Reference information
Fully digital system
Fully digital system
± 0.5% of sweep time displayed on screen
1, 2, 3, or 4 line, or field depending on mode
In 2-line sweep, the selected line is the first
displayed line.
Reference information
800 kHz
3.4 MHz (6.8 MHz for 1080P 148.5 MHz
formats)
Fully digital system
Fully digital system
Fully digital system limited by sample
resolution
P is displayed on horizontal axis and P
B
displayed on vertical axis
Vectors between the high luma and low luma
threshold are displayed
Reference information
1 ± 0.1% relative to flat gain
1 ± 0.1% relative to flat gain
For 1080P 148.5 MHz formats:
≤3 dB attenuation at 9 MHz
≥25 dB attenuation above 30 MHz
Specifications
is
R
3