Creating A Channel - Christie M Series User Manual

The first five items in this table are analog RGB with various sync combinations indicating Sync Source
when editing the channel:
Abbreviation
—
4WH
4WV
SG
5W
5WR
SVid
CVid
Dig
DSDI
DVI
HDMI
HSDI
SDI
3GA
3GB
DP
1. To display the Main menu, press Menu from the presentation level.
2. To display the Channel Setup menu, press 3 or move the highlight to the Channel Setup option
and press Enter.
3. To see the remaining channels not visible in the initial display of channels, press the Up and
Down keys.

Creating a channel

To use a new source with the projector, a new channel must be created so that the projector responds
to an input signal from that source.
A new channel can be created automatically, or it can be copied from an existing channel and then
edited as necessary.
When you select a direct input (Slot 1, Slot 2, Slot 3, or Slot 4), any existing channels in the projector
are searched for matching input and signal parameters–this only occurs if Auto Source is enabled on
these channels. If no match to the incoming input signal is found in currently defined channels, a new
channel is temporarily created based on factory-defined defaults for this type of signal. The channel
number assigned is the lowest available number from 01-99.
Note the following:
M Series User Guide
020-101948-02 Rev. 1 (08-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Signal types
No Sync
Composite (four wire) on HC input
Composite (four wire) on V input
Sync-on-green (four wire)
Separate H,V (five-wire)
Separate H,V swapped (five-wire)
S-Video
Composite Video
Digital
Digital Dual Link HD-SDI
Digital DVI
Digital HDMI
Digital HD-SDI
Digital SDI
Digital 3G-SDI (Level A)
Digital 3G-SDI (Level B)
DisplayPort
Managing channels
24