Locking Image Frames To The Input; Automatically Searching For Input Signals - Christie M Series User Manual

Hide thumbs Also See for M Series:

Table of Contents

Locking image frames to the input

When the selection is set to Frame Lock, output image frames are locked to the input. When locked,

the output is always locked to the primary input, never the secondary image.

1. Select Configuration > Option Card Settings.

2. To set the output to close at 60Hz for all sources, select Free Run.

Seamless switching is only available when free run is selected. When switching to a new input

with frame locking enabled, the image is black for the short period while the system locks onto

the new input.

Configure the behavior when no signal is found for the picture-in-picture.

1. Select Input Switching & PIP.

2. To continually search for the next valid signal when no signal is present or when loss of sync

occurs on the current user selected input, enable Auto Input Switching.

In the case of multiple signals to choose from, the order is based on slot, followed by inputs on

that slot.

M Series User Guide

020-101948-02 Rev. 1 (08-2018)

Displaying picture-in-picture

Table of Contents