Setting The Date And Time; Changing The Language Used For Menus; Adjusting The Menu Appearance - Christie M Series User Manual

E Current Status Bar provides information messages
according to the current status of the projector.
F Projector Information section is read-only.

Setting the date and time

Configure the date and time of the projector.
Any change to the date and time resets the projector real-time clock.
1. Click Configuration > Date & Time.
2. Change the date and time.
3. Click OK.

Changing the language used for menus

Choose the available language to use in the projector menus.
In the Configuration menu, select the language from the list.
The change takes effect immediately.

Adjusting the menu appearance

Change the appearance, content and/or location of on-screen menus and messages.
1. Select Configuration > Menu Preferences.
2. Configure the following:
• Large Menu Font—Enter a check mark to enlarge menus and their text.
• Menu Location—Use the pull-down list to choose a pre-defined default or customized
location for the display of all on-screen menus.
To create a custom menu location:
a. Choose a preset that is closest to the desired location.
b. Adjust Horizontal Shift and Vertical Shift slide bars to move the menu to the
desired location. Avoid locations too close to a corner or edge to prevent cropping of
larger menus.
• Display Automatic Message Boxes—Enable or disable the pop-up of automatic
message boxes. These are messages to the user that are not directly triggered by user
actions. Examples are signal information, function limitation, or auto calibration message
boxes.
• Display User Message Boxes—Enable or disable the pop-up of message boxes that are
directly triggered by user actions, for example gamma or lens control message boxes.
• Display 3D Message Boxes—Enable or disable message boxes that are triggered by 3D
setup errors.
• Display Error Messages—Choose how to be notified of errors detected in either the
incoming signal or projector.
M Series User Guide
020-101948-02 Rev. 1 (08-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
K OSD (on-screen display) section contains an On
and Off button. Only one is enabled depending on
the current state of the projector's on-screen
display.
Operating the projector
16