Using The Built-In Keypad; Using The Wired Remote; Ir Remote Keypad - Christie M Series User Manual

Up to a maximum of three users can connect at any given time. Two users can use the same
account to log in. Each user sees a different set of tabs. The default passwords can be edited
by an administrator or a service user in the Admin tab. Guest users do not see this tab. Basic
operations of the projector can be controlled from this interface and the Virtual OSD can be
accessed from here.

Using the built-in keypad

The built-in keypad has a LCD status display window which displays all states of the keypad controls.
The LCD displays status information when the projector is powering up and when the projector is
cooling down. The display shows the state of the keys, menu structure, and menu items.

Using the wired remote

Convert the remote keypad into a wired remote keypad using any standard 3-pin XLR cable (male to
female).
Connect one end into the remote and the other to the XLR connector on the Wired Keypad input panel.
The wired remote is recommended when:
• The built-in keypad is inaccessible.
• The lighting conditions are unsuitable for proper IR transmission

IR remote keypad

The IR remote keypad controls the projector by way of wireless communications from a battery-
powered infrared (IR) transmitter.
To use the IR remote, direct the keypad toward the projector's front or rear IR sensor and press a
function key. One of the two IR sensors on the projector detect the signal and relay the commands for
internal processing. The remote also offers a connector for wired connections to the projector.
M Series User Guide
020-101948-02 Rev. 1 (08-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Operating the projector
11