Connecting A Word Clock Source; Connecting A Video Source; Connecting E-Madi 64 Audio (Using Coaxial Or Fiber Cable) - ClearCom Eclipse HX-Median User Manual

Note:
Card Properties always defaults to the E-MADI64 standard for the number of
channels:
E-MADI64 channel mode
32
56
64
5) Apply the changes to the frame with a reset.
6.4.1

Connecting a Word Clock source

If you connect the Word Clock source to the Clock Input connector on the rear card (see
Table 16 above):
• The WRD LED on the front of the E-MADI64 card is lit
the word clock has been detected and locked onto.
• The number of configured ports and the detected sample rate (as provided by the
word clock) is indicated by
E-MADI64 card.
• The Error LED on the E-MADI64 card is lit
6.4.2

Connecting a video source

If you connect a video source to the Clock Input connector on the rear card (see Table 16
above):
• The VID LED on the front of the E-MADI64 card is lit
word clock has been detected and locked onto.
• The number of configured ports and the sample rate (configured in EHX) is
indicated by
6.4.3

Connecting E-MADI 64 Audio (using Coaxial or Fiber cable)

When you connect the external E-MADI64 Audio (using Coaxial or Fiber cable) to the rear of
theE-MADI64 card:
72 Eclipse HX-Median User Guide
Card Properties permits sample rate selection when synching to video
signals. It is only used when not using the Word Clock Source Sync (see
below).
Sample rate
96k
44.1k or 48k
44.1k or 48k
Table 16: E-MADI 64 channel modes
flashing green
flashing green LEDs (1:1 at 0.5Hz) on the front of the E-MADI64 card.
Configurable ports
32
56
64, 32 or 16
solid green, indicating that
LEDs (1:1 at 0.5Hz) on the front of the
solid red.
solid green, indicating that the