Denso BHT-100BW-CE User Manual page 49

Power Properties
Volume & Sounds Properties
On the Control Panel window, double-tap Volume & Sounds, and the Volume & Sounds properties
window appears.
On the Control Panel window, double-tap Power, and the Power
Properties window appears.
You can specify the idle period during which the BHT in either of the
following states waits for any event. After that period, the BHT enters
the suspend mode (Auto power-off).
- On battery power: When the BHT is driven by the battery cartridge.
- On external power: When the BHT is being charged by the CU-7000
Tap the Volume tab to display the screen shown at left.
You can make the following settings:
- Adjust the beeper volume except volumes for key entry and screen
taps
- Enable/disable the beeper for events
- Enable/disable the beeper driven by programs
- Enable/disable the beeper for notification
- Adjust the beeper volume for key entry
- Adjust the beeper volume for screen taps
You may adjust the beeper volume to six levels (0 to 5) on this
screen; however, four levels are available in practice since levels
1 and 2 and levels 3 and 4 produce the same volume.
Tap the Sounds tab to display the screen shown at left.
You can configure beeper sounds for various events.
36