Preparation; Setting-Up 1: Loading The Battery Cartridge - Denso BHT-100BW-CE User Manual

2.3

Preparation

2.3.1

Setting-up 1: Loading the battery cartridge

Before the first use of the BHT, be sure to load the battery cartridge as shown below. The battery
cartridge is not loaded in the BHT when shipped from the factory.
(1) Charge the rechargeable battery cartridge. (Refer to Section 5.5.)
(2) Turn the BHT upside down.
(3) Slide and hold the battery release lock open with the stylus and insert the battery cartridge into the
BHT until it clicks into place. (To remove it, make sure that the BHT is turned off. Slide and hold the
battery release lock open with the stylus and press the release button.)
Battery release lock
Stylus
• Never disassemble or heat the battery cartridge, nor put it into
fire or water; doing so could cause battery-rupture or leakage
of battery fluid, resulting in a fire or bodily injury.
• Do not carry or store the battery cartridge together with
metallic ball-point pens, necklaces, coins, hairpins, etc.
Doing so could short-circuit the terminal pins, causing the
batteries to rupture or the battery fluid to leak, resulting in a
fire or bodily injury.
• Avoid dropping the battery cartridge or letting it undergo any
shock or impact.
Doing so could cause the batteries to break, generate heat,
rupture or burn.
• Never charge the rechargeable battery cartridge where any
inflammable gases may be emitted; doing so could cause fire.
• Do not use batteries or power sources other than the specified
ones; doing so could generate heat or cause malfunction.
Battery cartridge
Release button
18