Interfacing With The Host Computer - Denso BHT-100BW-CE User Manual

5.4.3 Interfacing with the Host Computer

This section describes how to start communication with the host computer from System Menu. The
same may apply when you use a user program.
(1) Turn the host computer on.
(2) Plug the AC adapter of the CU-7000 into a wall socket.
(3) Make sure that the BHT is turned off, then set it on the CU-7000.
(4) On the host computer, initiate a communications program that can use Ymodem.
(5) Turn the BHT on and run System Menu. Select "2:Communication" and "1:Ymodem" to start
"SerialTransfer."
Regarding the interface port: Select the "IrDA (COM4:)."
(6) To transfer data stored in the BHT to the host computer, select "UPLOAD. To transfer data from the
host computer to the BHT, select "DOWNLOAD." (For details, refer to Chapter 2, Section 2.4.3
"Operating System Menu.")
The BHT and the host computer will start communication with each other via the CU-7000. The
DATA LED on the CU-7000 will come on upon start of communication. After completion of
communication, the LED will go off.
(7) Unplug the AC adapter of the CU-7000 from the wall socket.
Chapter 5 Handling the
109
CU-7000 (Option)