Operating Mode Keys - Siemens SIJECT15 Operation Manual

Operator panel keys
2.7

Operating mode keys

General You can start the machine in different mode: Semi-Auto mode, Timer-
Full-Auto mode, Sensor-Full-Auto mode, Manual mode and Mold
adjustment mode.
When machine starts for the first time, select Semi-Auto mode, Timer-
Full-Auto mode, Sensor-Full-Auto mode. The function is actuated only
after the Run key is pressed, and the safety door opens hereafter. For
Manual mode and mold adjustment mode, it is not necessary to use Run
key.
Semi-Auto
mode key
First set all the recipe data, then press this semi-auto mode key and wait
for the LED on.
Press the RUN key
cycle.
Another cycle should be started by pressing RUN key
safety door is opened/closed once.
Lubrication can be done automatically if the machine has run more times
than the lubrication counter setting number.
Timer-Full-Auto
mode key
Set all the parameters necessary (including total cycle time), press this
Timer-Full-Auto mode key and wait for the LED on.
Press the RUN key
the cycle automatically, until the set product quantity has been reached.
Then the machine stops and LED off.
Lubrication can be done automatically if the machine has run more times
than the lubrication counter setting number.
Sensor-Full-
Auto mode key
Set all the parameters necessary (including part counter), press this
Sensor-Full-Auto mode key and wait for the LED light on.
Press the RUN key
the cycle automatically, until the set product quantity has been reached.
Then the machine stops and LED off.
2-12
. Machine will start automatically for one
to start the system. The machine will execute
to start the system. The machine will execute
SIJECT 15/16 Operation Manual June, 2003
again, or