Siemens SIJECT15 Operation Manual page 28

Operator panel keys
Core 2 key
Press the middle Core 2 key to enter Core 2 screen.
Input corresponding parameter for core 2, such as position, pressure,
flow, time and counting.
Keep pressing the left key to let core 2 in.
Keep pressing the right key to let core 2 out.
Air-blow key
Press the middle Air-blow key to enter Air-blow screen.
Input corresponding parameter (position and time) for Air-blow 1 and Air-
blow 2.
Air-blow 1 will work if you press the left key.
Air-blow 2 will work if you press the right key.
Press the Air-blow key again to enter Core 3 screen.
Input corresponding parameter (pressure, position, flow and time) for
core 3 in/out.
Keep pressing the left key to let core 3 in.
Keep pressing the right key to let core 3 out.
Mold adjustment key
Press the middle Mold adjustment key to enter Mold adjustment
screen.
Input pressure and flow for mold adjustment. There are two ways to
adjust mold. When manual mold adjustment is selected, you can set
pulse here. If auto mode is selected, you can set the time of adjusting.
Mold adjustment retracts if you keep pressing the left key.
Mold adjustment advances if you keep pressing the right key.
2-10 SIJECT 15/16 Operation Manual June, 2003