Siemens SIJECT15 Operation Manual page 31

During this process, when a cycle is finished, the sensor will check
whether the product has fallen down. If it is OK, the next cycle will run
successfully. Otherwise, alarm is on and the machine will stop.
Lubrication can be done automatically if the machine has run more times
than the lubrication counter setting number.
Manual mode
Key
This mode shall work with other manual operating keys together.
Press manual mode key and the LED is on.
In manual operating area, press the middle key to open the desired
screen. Input necessary parameters and press the manual left key or
right key to continue every action.
System will run continuously until you release the key, or when the timer
or counter is full.
Following operations can be carried out in this mode, they are:
Mold open/close; ejector advance/retract; injection/suck back; charge;
core 1 in/out; core 2 in/out; core 3 in/out; air blow 1 & 2 and
lubrication/purge.
This mode can also be used to reset the parameters and clear the alarm.
Mold Adjustment
mode key
This mode is especially used for mold adjustment when a new mold is
installed in the machine.
Following operations can be carried out in this mode, they are:
Mold open/close; ejector advance/retract, injection/decompression,
charge, mold adjustment advance/retract and lubrication.
Press this Mold adjustment mode key and mold adjustment key
enter mold adjustment screen. Input the parameters, then press mold
adjustment advance/retract key to adjust mold manually, or press auto
start key to start auto mold adjustment.
To protect mold from damaging, the mold open/close in this mode should
keep a low speed and invariable pressure and flow.
Run key
Stop key
SIJECT 15/16 Operation Manual
Run key is to run Semi-Auto mode / Timer-Full-Auto mode / Sensor-
Full-Auto mode.
Operator panel keys
to
2-13