Siemens SIJECT15 Operation Manual page 59

SIJECT OP15B Screens
Injection end (InjEnd) －End position of injection, in mm.
Holding end (HldEnd) －End position of pressure holding, in mm.
Charging end (ChaEnd) －End position of charging, in mm.
Ejector advance end (EjeEnd) －End position of ejector advance, in
mm.
Mold protection time (MProTm) － Time of low-pressure mold
protection, in second.
Mold lock time (MLckTm) －Time of high-pressure mold lock operation,
in second.
Injection time (InjTm) － Total time of 4 stages injection, in second.
Cycle time (CycTm) － Time record of every machine cycle, in second.
Charging time (ChaTm) － Time record of every charging operation, in
second.
SIJECT 15/16 Operation Manual 3-25