Siemens SIJECT15 Operation Manual page 83

SIJECT OP15B Screens
Core in position (CorInPos) － set the position to do core in. The core
in can be at the start of mold close, during mold close, or at the end of
mold close.
Core out position (CorOutPos) － set the position to do core out. The
core out can be at the start of mold close, during mold close, or at the
end of mold close.
Mold position (MldPos) － display the current position of mold.
Press soft key F3 "Core in" to insert the core into mold, and press F4
"Core out" to do core out.
SIJECT 15/16 Operation Manual 3-49