Siemens SIJECT15 Operation Manual page 82

SIJECT OP15B Screens
Mold position (MldPos) － display the current position of mold.
Press Manual Core 1 in key
Manual Core 1 out key
On Core 1 screen 1 (see Fig 3-36), press softkey F5
1 screen 2. See Fig 3-37. Core 3 in/out can be set here.
The screen displays the core 1 in/out status, and the related parameters
can be set here, including the position, pressure, flow, time and counter.
The core operation can be controlled by position, by time, or by counter.
Core 3 in － set the pressure and flow for core 3 in. If it is by position,
then position value should be set. If it is by time, then the time should be
set as a parameter and the actual time will be displayed. If it is by
counter, then the counter should be set and the actual counting value will
be displayed.
Core 3 out － set the pressure and flow for core 3 out. If it is by position,
then position value should be set. If it is by time, then the time should be
set as a parameter and the actual time will be displayed. If it is by
counter, then the counter should be set and the actual counting value will
be displayed.
Core 3 selection (CorSelect) － select or deselect core 3 in/out.
Core 3 mode (CorMode) － select position mode, time mode or counter
mode.
3-48
to do core out.
Fig 3-37 Core 1 in/out --- screen 2
SIJECT 15/16 Operation Manual June, 2003
to do core in manually, and press
to enter Core