Siemens SIJECT15 Operation Manual page 62

SIJECT OP15B Screens
Linear Scale mold:
Switch --- Proximity switch signal. When mold close is at position, the
box will backlight, showing the reference point of linear scale.
Reference point --- setting value. Mold lock end should be the reference
of linear scale.
Length --- setting value. The length of linear scale can be set here,
ranged from 1～6553mm.
Actual value --- displayed value. Display the actual value of linear scale.
Current value --- displayed value. It is the difference from actual value to
reference point.
Linear scale injection:
Reference point --- setting value. Reference point of linear scale can be
set here.
Length --- setting value. The length of linear scale can be set here,
ranged from 1～6553mm.
Actual value --- displayed value. Display the actual value of linear scale.
Current value --- displayed value. It is the difference from actual value to
reference point.
Linear scale ejector:
Switch --- Proximity switch signal. When ejector retract is at position, the
box will backlight, showing the reference point of linear scale.
Reference point --- setting value. Ejector retract end should be the
reference of linear scale.
Length --- setting value. The length of linear scale can be set here,
ranged from 1～6553mm.
Actual value --- displayed value. Display the actual value of linear scale.
Current value --- displayed value. It is the difference from actual value to
reference point.
Linear scale ejector --- Linear scale ejector can be selected or
deselected here.
3-28 SIJECT 15/16 Operation Manual June, 2003