Hitachi SJ Series User Manual page 236

Chapter 12
Disabled functions
！
• The following functions cannot be used when the
synchronous motor (permanent magnet motor)
control is conducted.
• Even when they are enabled by parameters of
setting, they are actually disabled.
Item
Functions associated with
torque control
Over current restraining
function
Functions associated with
induction motor control
Part of gain mapping
function
Part of auto-tuning
Commercial power supply
switching function
Acceleration or
deceleration cancellation
function
Jogging Operation
Parameter
[FA-15], [FA-16], [dA-15], and [dA-16]
[Ad-01] to [Ad-04], and [Ad-40] to [Ad-43],
Input terminal 067 [ATR]
[Ad-11] to [Ad-14], Input terminal 068 [TBS]
[bA110] to [bA116], and [bA210] to [bA216],
Input terminals 060 [TL], 061 [TRQ1], and
062 [TRQ2]
Output terminal 022 [TRQ]
[CE120] to [CE123], Output terminal 019
[OTQ]
[bA120] and [bA121]
[HA110]
[Hb130], [Hb131], [Hb140] to [Hb142],
[Hb145], [Hb146], [Hb150] to [Hb163],
[Hb170], [Hb171], and [Hb180]
[HC101] and [HC102]
[HC110] to [HC114], [HC120], and [HC121]
[HA126],[HA129]
[HA-01]=02
[HA-03]
Input terminal 035 [CS]
Input terminal 071 [LAC]
[AG-20]、[AG-21]、Input Terminals029[JG]
12-9-19
• In the following table, only the common settings
(parameter center "-") and the first settings
(parameter center "1") are listed, but it is not
possible either to use the second settings
(parameter center "2") that correspond to the first
settings in the following table.
Torque command monitoring
function
Torque controlling function
Torque biasing function
Torque limiting function
Over torque signal
Over current restraining function
Stabilization adjustment gain
Functions associated with V/f
control
Functions associated with
automatic boost
Sensorless vector control,
Zero-speed range sensorless
vector control
Constant for I control
Rotating system tuning
Online auto-tuning
Switching to commercial power
supply
Acceleration or deceleration
cancellation function
Jogging Operation Function
Inverter Function
Description