Hitachi SJ Series User Manual page 189

Chapter 12
12.5.2 Operation on operator keypad
Ｑ
• Want to make trial operation from the operator
keypad.
• Want to make operation from the operator keypad.
Ａ
• The operator keypad is used to give a frequency
command.
• Use "Operation key" and "Stop key" to make and
stop operation, respectively.
• For operation using the operator keypad, the
operation direction can be changed by setting
RUN key direction selection [AA-12].
Parameters
Item Parameters
Operation
command [AA111]
selection
RUN key
direction [AA-12]
selection
Output
[CC-01]~
terminal
[CC-07]
function
！
• The output of the inverter requires not only an
operation command but also a frequency
command.
• If the forced operation 023 [F-OP] of the terminal
function is enabled, the command destination
specified in the [F-OP] function becomes effective
irrespective of the present setting.
Data
Operation command from "Operation key"/"Stop key"
02
on the operator keypad.
00 Forward rotation command from the operator keypad.
01 Reverse rotation command from the operator keypad.
[REF] ON when an operation command can be given
011
from the operator keypad.
12-5-2
Inverter Functions
Description