Table of Contents
Advertisement
OPERATION
3.12.7 Setting Maximum Analog Output
Levels
The maximum
output levels of the X and Y outputs can
be programmed
to values between 1 and lOV, and the Z
output blanking level can be set to high or low by using
the OTHER key, as described in the following
paragraphs.
The full scale values can be changed at any time without
affecting other operating
modes. Table 3-8 summarizes
keystroke sequences and display
messages for each of
these programming
modes.
OTHER BUTTON
X Output Level Programming-The
full scale X output can
be programmed
to values between 1 and 1OV with 1pV
resolution.
To program the X output
lcvcl, perform the
following
sequence.
1. Press: SHIFT, OTHER, 4, or SHIFT, OTHER, A, A, A,
Mode
example, to progran,
a WV value, pwss: 5, ., I
ENTER.
Table 3-8. XY Mode Level Programming
x Output
Full Scale Value
Y Output
Full Scale Value
Z Output
Manking
Level
Range
lV-1ov
1VlOV
Low or
Hieh
SHIFT, OTHER, 5
SHIF'I; OTHER, 6
Display
Message
x FS = 1o.oooooov
Y FS = '1O.OOOOOOV
% ISLANK = LOW
3-27
Advertisement
Table of Contents
