Table of Contents
Advertisement
KONTRON
To
find
the
location
of
the
parallel
Appendix E: Connector Layout chapter.
14.2 Configuration
The parallel-port mode, I/O addresses, and IRQs are changeable
from the BIOS Setup Utility. You can program the base I/O-
address 378h (default), 3BCh or 278h. You can set the parallel
port mode to disable, enable or AUTO (default). You can choose
IRQ5 or IRQ7 as the parallel-port interrupt.
Refer to the I/O Device Configuration Submenu in the Appendix B:
BIOS
Operation
chapter
for
configuration.
coolMONSTER/PM User's Guide
39
port,
please
see
the
additional
information
on
Parallel Port Interface
15. EIDE Interfaces
PCI-bus devices serve as primary and secondary IDE hosts on the
coolMONSTER/PM. The controller supports:
†
Up to Ultra DMA 100 mode
†
Up to PIO mode 4 timing
†
Multiword DMA mode 1 and 2 with independent timing
The controller also supports IDE legacy and IDE native mode
configuration. The coolMONSTER/PM features two IDE interfaces
that can drive four hard-disk drives. When two IDE devices share
a single adapter, they are connected in a master/slave, daisy-
chain configuration. If only one drive is in the system, you
must set it as the master.
IDE Interfaces
40
KONTRON
coolMONSTER/PM User's Guide
Advertisement
Table of Contents
