Table of Contents
Advertisement
KONTRON
11.2 Connector
The 10/100Base-T interface is available on a standard 8-pin RJ45
jack. It is available at the slot panel of the coolMONSTER/PM
through Connector
X7.
To find the location of the Ethernet interface, please see the
Appendix E: Connector Layout chapter.
The following table shows the pin-out of the Ethernet connector.
Header
Pin
Signal Name
1
TXD+
2
TXD-
3
RXD+
4
NC **
5
NC **
6
RXD-
7
NC **
8
NC **
L
Left LED
R
Right LED
NOTE: (**) Do not connect anything to these pins!
11.3 Configuration
The onboard LAN controller can be enabled or disabled in the
BIOS Setup Utility. Additionally it is possible to enable the
onboard LAN PXE boot ROM to allow the system to boot up via a
network connection from a PXE boot server. Refer to the I/O
Device Configuration Submenu in the Appendix B: BIOS Operation
chapter for additional information on configuration.
You can download available drivers from the Kontron Web site.
For
further
information
read
technical support.
coolMONSTER/PM User's Guide
27
Function
In/Out
100/10BASE-T Transmit
Differential Output
100/10BASE-T Transmit
Differential Output
100/10BASE-T Receive
Differential Input
For internal use only
For internal use only
100/10BASE-T Receive
Differential Input
For internal use only
For internal use only
Activity
Green
Link
Yellow
the
read-me
file
or
contact
Ethernet Interface
11.4 Ethernet Technical Support
If any problems occur, you can solve some of them by using the
latest drivers for the Intel® LAN controller. Kontron provides
you with the latest Kontron-tested drivers, which can differ
from newer ones. For further technical support, contact either
Kontron or get support information and downloadable software
updates from Intel®.
Ethernet Interface
28
KONTRON
coolMONSTER/PM User's Guide
Advertisement
Table of Contents
