IRIS IRMA MATRIX 2 Installation Manual page 5

5/74 IRMA MATRIX R2 CAN Installation manual
released
12.3.2 Installations with sCON-F-12 ................................................................................................... 68
12.3.3 Installation with second power supply in articulated bus (with sCON-S) ................... 68
13
Table of illustrations
Fig. 1:
Fig. 2:
Fig. 3:
Fig. 4:
Fig. 5:
Fig. 6:
Fig. 7:
Fig. 8:
Fig. 9:
Fig. 10:
Fig. 11:
Fig. 12:
Fig. 13:
Fig. 14:
Fig. 15:
Fig. 16:
Fig. 17:
Fig. 18:
Fig. 19:
Fig. 20:
Fig. 21:
Fig. 22:
Fig. 23:
Fig. 24:
Fig. 25:
Fig. 26:
Fig. 27:
Fig. 28:
Fig. 29:
Rev. 1.6 2018-09
Annex B Drilling patterns .......................................................................................... 74
Comparison - DHCP deactivated in old counting firmware ............................ 11
Comparison - deactivated buttons under "Installation" .................................. 11
Example of installation conditions in the upper part of the door trim ........ 12
Maximum distance to the end of vehicle inside wall ....................................... 14
Label on the rear - Observe mounting orientation!........................................... 15
Determination of the center of the clear passage width ................................. 15
Mounting of the surface mount version .............................................................. 18
sCON-S (standard) - overview of the connection components ..................... 19
Mounting with mounting set and sCON-S (standard) - overview ................. 20
Setting, adjusting and tightening of the cylinder head screws ..................... 21
Pushing the spring holders in place and screwing them tight ....................... 21
Connector version sCON-F-12 w/ Surface mount version sensor ................. 22
Mounting with sCON-F-12 - overview ................................................................. 23
sCON-F-12 - positioning and adjustment ............................................................ 24
Selection of the number of IRMA MATRIX sensors ........................................... 26
Central installation position - 1 IRMA MATRIX sensor ..................................... 26
Distance (X) of two sensors depending on the door height ............................ 27
2 IRMA MATRIX sensors per door (X = sensor distance) ................................... 28
sCON-S (standard): Threaded hole for attaching the grounding cable ........ 30
sCON-F-12: threaded holes for connecting the grounding cable .................. 31
Mounting holes for attaching the grounding cable .......................................... 31
Power supply, sensor with fuse and timing relay for 30 minutes of after-run
power ............................................................................................................................. 34
Connection of the CAN-USB converter to H couplers ....................................... 43
Opening of the BUS with H coupler for connection of the CAN-USB
converter ....................................................................................................................... 44
PC connection via sCON-S (standard) with additional Ethernet interface .. 45
Service connection to an installation with sCON-F-12 ..................................... 46
Version of the service software program - Menu point "?" - please check! 47
Sensor selection and firmware ............................................................................... 47
DHCP option in the tab „Ethernet" ........................................................................ 48