Figure 2-3 Feature Configuration Screen; Figure 2-4 Fast Feature Code Dialog - Comtech EF Data Vipersat CDM-570 User Manual

To enter the feature codes, enter Y at the command prompt, then enter the 20
digit FAST Feature Code, as shown in figure 2-4.
Tip: The network administrator will have the FAST Feature codes. These are
4.
C h ap t e r Q u i c k S t a r t C o n f i g u r a t i o n
2 -
Figure 2-3
Figure 2-4
generated and stored by the unit serial number for the target CDM-570/
570L. The target unit's serial number can be found on the rear of the unit
chassis.
After entering the FAST Feature code, return to the Administration
screen (shown in figure 2-2) by entering X at the command prompt from
the Feature Configuration menu. Ensure that the Working Mode is set to
Router-Vipersat.
If it is not, enter C and change the setting by selecting 4, as shown in
figure 2-5. The unit will automatically reboot in order to implement the
change for this setting.
Feature Configuration screen
FAST Feature Code dialog
I n i t i a l C o n f i g u r a t io n
2-5