KSB BoosterControl Advanced Installation & Operating Manual page 61

Parameter Description
Leakage detection
3-3-5
Activating leakage monitoring
MPO Functionality
3-3-6
Synchronous operation
PumpMode int/ext
3-3-7
Setting for pump mode via HMI (internal)
or switch (external)
System settings
3-4
Parameterisation of system
Inlet
3-4-1
Suction-side parameterisation
Sensor press. 4 mA
3-4-1-1
Analog measured value at 4 mA, suction
side
Sensor press. 20 mA
3-4-1-2
Analog measured value at 20 mA, suction
side
Damp. Time Inlet
3-4-1-3
Damping time for smoothing measured
value to compensate for measurement
peaks
Level config
3-4-1-4
Configuring inlet tank control
0% level
3-4-1-4-1
Minimum water level at which no air enters
into tank, in percent, from upper edge of
inlet nozzle
100% level
3-4-1-4-2
Maximum water level of inlet tank, in
percent, from upper edge of inlet nozzle
Sensor level
3-4-1-4-3
Distance of sensor positioned above tank
floor to tank floor, in centimetres
Low level shut down
3-4-1-4-4
System stop when dry running level
reached
Low level reset
3-4-1-4-5
Resetting the system when defined dry
running level is reached
Critical water level
3-4-1-4-6
Threshold of critical water level in inlet tank
High water level
3-4-1-4-7
Threshold of high water level in inlet tank
Factory setting Possible settings
Off On,
off
Off Off,
On
Internal Internal,
external
- -
- -
0 -100.. 1000
1000 0.. 9999
200 100.. 2000
- -
0 0.. 99
200 0.. 999
0 -100.. 999
10 0.. 99
15 0.. 99
30 0.. 99
105 0.. 199
min. value max. value Read access right Write access right
- - Everybody
- - Service
- - Everybody
- - Everybody
- - Everybody
-100 1000 Everybody
0 9999 Everybody
100 2000 Factory
- - Everybody
0 99 Everybody
0 999 Everybody
-100 999 Everybody
0 99 Everybody
0 99 Everybody
0 99 Everybody
0 199 Everybody
Service
Service
Service
Nobody
Nobody
Service
Service
Factory
Service
Service
Service
Service
Service
Service
Service
Service