Commissioning/Start-Up/Shutdown; Ambient Conditions For Commissioning And Operation; Commissioning; Starting Up The System - KSB BoosterControl Advanced Installation & Operating Manual

34 of 88

8 Commissioning/Start-up/Shutdown

8 Commissioning/Start-up/Shutdown

8.1 Ambient conditions for commissioning and operation

Table 27: Ambient conditions for operation
Condition
Ambient temperature
Relative humidity
Installation altitude

8.2 Commissioning

A checklist can be used for commissioning. (ð Section 12.1, Page 81)

8.2.1 Starting up the system

See system documentation.

8.3 Setting BoosterControl Advanced

Note the general operating instructions. (ð Section 6, Page 21)
1. Select parameter 3-2-1-1.
2. Enter access level and associated password:
- Customer: 7353
Users logged in to BoosterControl Advanced are automatically logged off after 15
minutes of inactivity.

8.3.1 Setting the display language

1. Select parameter 3-1-1-1.
2. Select the language required and press "OK" to confirm.

8.3.2 Setting the time/date

BoosterControl Advanced does not automatically change between summer and
winter time.
1. To set the date, select parameter 3-7-1.
2. To set the time of day, select parameter 3-7-2.

8.4 Basic configurations of the pressure booster system

BoosterControl Advanced can be used for various operating modes of pressure
booster systems.
A set of preset parameters can be loaded for every operating mode.
The following operating modes are possible:
BoosterControl Advanced
Value
0 ... 50 °C
50 %
(non-condensing)
Max. 1,000 m above MSL
(higher installation altitudes are subject to a
reduction factor)