Connect The Ih1800Htx Exhaust Tms; Connect To Your Factory Extraction System (Optional) - Edwards iH80 Instruction Manual

Ih series. dry pumping system

Hide thumbs

Table Of Contents

Table of Contents

A590-00-880 Issue D

Incorporate flexible pipelines in the vacuum pipeline to reduce the transmission of vibration and to prevent

loading of coupling-joints. We recommend that you use Edwards braided flexible pipelines. The pipelines

should be suitable for 110 °C.

Adequately support vacuum/exhaust pipelines to prevent the transmission of stress to pipeline

coupling-joints.

Incorporate a pressure gauge in the inlet pipeline, so that you determine that the iH system operates

correctly.

You must be able to isolate the iH system inlet from the atmosphere and from your vacuum system if you

have pumped or produced corrosive chemicals.

The outlet of the exhaust pipe can have a check-valve fitted which prevents the suck-back of exhaust

vapours after the iH system is shutdown. The check-valve also provides additional attenuation of the pulses

in exhaust pressure.

On very dusty applications, use a low-impedance inlet-filter to minimise damage to the pump.

The exhaust pipelines should be suitable for 150 °C for HTX systems.

1. Remove the temporary cover or blanking plate from the inlet of the iH system. Retain the nuts, bolts, washers

and blanking plate for future use. Retain the temporary cover for future use on non-contaminated pumps only.

2. Use the O-ring supplied and suitable nuts, bolts and washers (not supplied) to connect the inlet-flange

item 5) of the iH system to your vacuum system.

3. Use the NW40 trapped O-ring and clamp supplied to connect the exhaust outlet

pipe, to your exhaust extraction system. If check valve/elbow are not required for your application refer to the

web.

3.4