TOHATSU MD 40B2 Owner's Manual page 80

80
INSPECTION AND MAINTENANCE
Description
*1
Warning system
Bolts and Nuts
Sliding and Rotating Parts.
Grease Nipples
Outer Equipment
Anode
*1: Have this handled by your dealer
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the
best time for major maintenance procedures to be carried out.
ENOM00093-A
Fuel filters and fuel tank cleaning
ENOW00093-A
Gasoline and its vapors are very flammable
and can be explosive.
Do not start this procedure while engine
is operating or hot even after stopping it.
Place fuel filter away from every source of
ignition such as sparks or open flames.
Wipe off gasoline well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
10
ment protection regulations.
Install fuel filter with all related parts in
place, or fuel leak could occur, leading to
catching fire or explosion.
Check fuel system regularly for leakage.
Contact authorized dealer for fuel system
services. Services by unqualified person
could lead to engine damage.
Fuel filters are provided inside the fuel
tank and engine.
Inspection intervals
First 20 Every 50
hours of 1 hours of 3
month months
WARNING
Every 100 Every 200
Inspection procedure
hours of 6 hours of 1
months year
Check function
Retighten
Apply and pump in grease.
Check for corrosion.
Check for corrosion and deformation.
ENOM00094-0
Fuel filter (for engine)
1. Check in the cup for water and
debris.
1. Body
2. O-ring
3. Filter
4. O-ring
5. Cup
6. Arrow to indicate fuel flow direction
2. If present, disconnect hoses from
the fuel connector (male) and the
fuel pump.
3. Remove the cup, filter and O-rings
from the fuel filter body.
Remarks
Replace if neces-
sary.
1
2
3
4
5
ENOF00096-B
6