TOHATSU MD 40B2 Owner's Manual page 63

allow water to drain from inside the
engine.
ENOM00062-A
Manual Tilt type (*30, 40, 50 only)
Tilt up
Push the reverse lock lever down until it
stops. (This is the tilt up position.) Now,
tilt the outboard motor all the way up
until it is locked in place.
1
2
3
1. Reverse lock lever
2. Tilt up position
3. Tilt down position
ENOM00063-0
Tilt down
Pull the reverse lock lever upward until it
stops. (This is the tilt down position.)
Now, lift up the outboard motor slightly,
and then allow gravity to lower it for you.
1. Reverse lock lever
2. Tilt up position
3. Tilt down position
ENOM00069-A
Power Trim & Tilt type
Tilt up
1. Operate the Power Trim & Tilt switch
and tilt the outboard motor up.
2. Lock the tilt with the Tilt stopper
after the outboard motor has been
ENOF00059-0
tilted up
Tilt down
1. Release the tilt stopper from the
set-up position while slightly tilting
up outboard motor.
2. Operate the Power Trim & Tilt switch
and tilt the outboard motor down
until the motor touches to the thrust
rod.
ENOF01317-0
ENGINE OPERATION
1
2
3
UP
DN
63
ENOF00059-0
7
UP
DN
ENOF00067-A
ENOF00067-2