Engine Operation; Before Starting; Engine Oil Feeding - TOHATSU MD 40B2 Owner's Manual

ENGINE OPERATION

ENOM00042-0

Before starting

ENOW00022-A
CAUTION
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before star ting engine. ( To
properly fill the engine with oil follow the
instructions. See page 74)
1
3
1. Genuine of recommended engine oil
2. Filler lid
3. Oil tank cap
ENOW00027-A
CAUTION
Before starting engine for the first time after
reassembling engine or off-season storage,
disconne ct stop switch lock and crank
approximately 10 times in order to prime the
oil pump.
ENOM00656-A

1. Engine oil feeding

When the engine is new or have been
left without operation for a long time, or
just after the engine is overhauled, be
sure to execute the following operation
for forcedly feeding the engine oil to the
oil line before starting the engine.
ENOM00657-0
30, 40, 50 type
a. Disconnect the link rod by turning the
b. Make sure that the oil pump control
c. Idle the engine for more than 30 min-
2
d. Reset the link rod to the advancer
30, 40, 50
ENOF00641-0
1. Rod snap
2. Link rod
3. Advancer arm
4. Cable joint
5. Throttle cable
6. R shaped pin
7. Nut
rod snap interlocking with the oil
pump as shown in the figure.
lever is set at open side position.
utes.
arm.
1
2
3
7
6
43
7
4
5
ENOF00651-0