Forward, Reverse, And Acceleration - TOHATSU MD 40B2 Owner's Manual

54
ENGINE OPERATION
E a c h tim e t h e m ain s wi t c h ke y is
pressed in the above manner, engine
speed changes as follows.
Starting
-1
700 min (rpm)
-1
800 min (rpm)
ENOM00046-A
5. Forward, reverse, and
acceleration
ENOW00037-0
Before shifting into forward or reverse,
make sure that boat is properly moored and
7
outboard motor can be steered fully to the
right and left. Make sure that no swimmer(s)
is ahead or astern of the boat.
ENOW00038-A
Attach other end of emergency stop
switch lanyard to the operator's PFD
(Personal Flotation device) or arm and
keep it attached during cruising.
Do not attach the tether to a part of
clothing that can be torn easily when
pulled.
Arrange the tether so that will not be
caught by any object when pulled.
Be careful not to pull the tether acciden-
tally during cruising. Unintentional stop of
engine can cause loss of control of out-
board motor. Rapid loss of engine power
can lead to falling down or causing pas-
senger(s) to be thrown overboard.
-1
800 min (rpm)
-1
900 min (rpm)
WARNING
WARNING
ENOW00042-0
WARNING
Do not shift into Reverse during planing,
or control will be lost leading to serious
personal injury, boat may swamp, and/or
hull may be damaged.
Do not shift into Reverse during cruising,
or control may be lost, falling down or
causing passenger(s) to be thrown over-
board. Leading to serious personal injury,
and ste er ing system and /or shif ting
mechanism may be damaged.
ENOW00861-0
WARNING
Do not shift at high boat speed, or control
may be lost, falling down or causing passen-
ger(s) to be thrown overboard. Leading to
serious personal injury.
ENOW00862-0
CAUTION
Gear and clutch damage may occur if shift-
ing at high engine speed.
Engine must be in the slow idle position
before shifting is attempted.
ENOW00863-0
CAUTION
Idle speed may be higher during warming up
of engine. If shifted to Forward or Reverse
during warming up, it may be difficult to
shift back to neutral. In such case, stop
engine, shift to neutral, and restart engine
to warm up.
ENON00014-0
Note
Frequent shifting to forward or reverse
can accelerate wear or degradation of
parts. In such case, replace gear oil earlier
than the period specified.