52
ENGINE OPERATION
4. Tie a loop in the another end of the
emergency starter rope and attach
socket wrench that is included in the
tool kit.
ENOW00860-0
Be sure to keep the harness away from the
7
rotation parts.
5. Be sure to install the stop switch lock
to the stop switch, and attach the
stop switch lanyard securely to the
operator or to the operator's PFD
(Personal Flotation Device.)
6. Set the control lever in the Neutral
position.
7. Pull the starter handle slowly until
you feel engagement, keep pulling till
you feel less resistance. Then pull it
quickly.
8. After engine starts, do not reinstall
flywheel cover and top cowl.
ENOF00663-0
CAUTION
ENOM00043-A
4. Warming up the engine
ENOW00932-0
CAUTION
Be sure to check that cooling water is com-
ing out of the cooling water check port dur-
ing warm up.
Warm the engine at low engine speeds
for about
3 minutes : above 5°C (41°F )
5 minutes at 2000 min
below 5°C (41°F )
This allows the lubricating oil to circu-
late to all parts of the engine. Operating
the engine without warm up shortens
the engine's life.
1
1. Idle port
2. Cooling water check port 30, 40, 50
1
1. Idle port
2. Cooling water check port 75, 90, 115
-1
(rpm) :
2
ENOF00664-0
2
ENOF00665-0