TOHATSU MD 40B2 Owner's Manual page 33

ENOW00085-0
WARNING
Do not hold propeller with hand(s) when
loosening or tightening propeller nut. Put a
piece of wood block between propeller
blade and anti-ventilation plate to hold pro-
peller.
ENOW00086-0
CAUTION
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
Propeller must be selected that will
allow the engine to reach recommended
maximum operating range during cruis-
ing.
Wide-open throttle rpm range
30/40 : 4750 – 5750 min
50 : 5150 – 5850 min
75/90 : :5150 – 5850 min
115 : 5150 – 5850 min
Genuine propellers are listed on PROPEL-
LER TABLE of this manual (See page 100).
1. Remove the split pin, propeller nut
2. Remove the propeller and thrust
3. Apply water proof grease to the pro-
4. Install the thrust holder, propeller,
30, 40, 50
ENOF00084-B
1. Propeller
2. Thrust holder
3. Stopper
4. Washer
5. Propeller nut
6. Split pin
75, 90
-1
(rpm)
-1
(rpm)
-1
(rpm)
1. Propeller
-1
(rpm)
2. Thrust holder
3. Bush
4. Adaptor
5. Washer
6. Propeller nut
7. Split pin
and washer.
holder.
peller shaft before installing a new
propeller.
stopper, washer and propeller nut
onto the shaft.
2
2
33
INSTALLATION
6
5
3
5
4
1
ENOF01315-0
7
6
5
4
3
1
ENOF01335-0