Propeller Installation - TOHATSU MFS 40A Owner's Manual

can lead to poor performance of, and/or
damage to, the electrical system.
ENON00006-A
Note
Recommended battery: 12V 100Ah/5HR,
850 (Cold Cranking Amps (CCA), In case of
cold whether: 12V120Ah/5HR (1000CCA))
Specifications and features of batteries
vary among the manufacturers. Consult
the manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the out-
board motor.
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery,
and then connect the negative lead
(—). When disconnecting the battery
always remove the negative lead (—)
first. After connecting the positive
terminal (+), securely place a cap on
it to prevent short circuits.
1
1. Battery cord (red)
2. Battery cord (black)
ENOM00123-0

4. Propeller installation

ENOW00085-A
Do not begin propeller removal and installa-
t i o n p r o c e dur e w i t h s p a r k p lu g c a p s
attached, shift in forward or reverse, main
switch at other than "OFF", engine stop
switch lock attached to the switch, and
starter key attached, or engine could acci-
dentally start leading to serious personal
injury.
Disconnect battery cable if possible.
ENOW00085-0
Do not hold propeller with hand(s) when
loosening or tightening propeller nut. Put a
piece of wood block between propeller
blade and anti-ventilation plate to hold pro-
peller.
ENOW00086-0
2
Do not install propeller without thrust
ENOF00022-0
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
INSTALLATION
WARNING
WARNING
ENOF00084-B
CAUTION
25
5