TOHATSU MD 40B2 Owner's Manual page 77

ENOM00950-0
Fuse replacement
ENOW00923-0
CAUTION
Before replacing a fuse, disconnect the bat-
tery cable from the battery negative (-) ter-
minal. Failure to do so may cause a short-
circuit.
ENOW00924-0
CAUTION
Never use a fuse with a rating that exceeds
the specified rating as this could cause seri-
ous damage to the electrical system.
If a blown fuse is detected, try to deter-
mine the cause for this and correct it. If
the cause for the problem is not cor-
rected, the fuse will likely blow again.
If the fuse continues to blow, request an
authorized Tohatsu dealer to inspect
the outboard motor.
1. Stop the engine and disconnect the
battery cable from the battery nega-
tive (-) terminal.
2. Remove the engine cover.
3. Remove the fuse box lid.
4. Remove the fuse and check it. If the
fuse is blown, replace it with a fuse
of the same specified rating. The
outboard motor is supplied with
spare fuses in the spare fuse holder.
INSPECTION AND MAINTENANCE
30, 40, 50.
1
1. Blown fuse
75, 90
1
1. Blown fuse
77
ENOF01327-0
10
ENOF01329-0