TOHATSU MD 40B2 Owner's Manual page 74

74
INSPECTION AND MAINTENANCE
Item
Steering
Devices
Other parts
ENOM00082-A
Engine oil replenishing
ENOW00079-A
Do not add engine oil of brand and grade
other than existing one. In case engine oil
of other brand or grade is added, drain all
oil and ask dealer for treatment.
In case other than engine oil such as gas-
oline is put in the oil chamber, empty the
chamber and ask dealer for treatment.
When replenishing engine oil, be careful
not to allow entry of foreign matters such
as dust or water into oil chamber.
Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
Do not replenish engine oil over upper
limit. If overfilled, remove oil to upper
limit. If engine oil is over the upper limit,
it can leak and potentially lead to engine
damage.
If the oil level is low, or at lowest mark,
10
add recommended oil to the oil tank.
1. Open the filler lid from the top cowl.
2. Open the oil tank cap
3. Fill the oil tank with the genuine
engine oil.
4. After replenishing of the oil tank, be
sure to close the oil tank cap tightly.
• Check working of steering handle and remote control.
• Check if the anode and trim tab are securely installed.
• Check the anode and trim tab for corrosion and deformation.
CAUTION
Points to Check
1
1. Genuine of recommended engine oil
2. Filler lid
3. Oil tank cap
ENOM00083-A
Washing outboard motor
ENOW00081-0
Do not start engine without removing pro-
peller, or accidentally turning propeller
could cause personal injury.
ENOW00082-0
Never start or operate the engine indoors or
in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be fatal
if inhaled for any length of time.
Remedy
Repair if necessary
Replace
2
3
ENOF00641-0
WARNING
WARNING