Unpacking; Standard Packaging - ABB PowerWave 33 Series 3 User Manual

3.3 Unpacking

Prior unpacking make sure that the floor surface is solid and suitable for supporting the weight of all the
equipment. Bring the unit(s) close to the end position and unpack them by removing the packing and
shipping materials as described next.
UPS AND BATTERY CABINETS ARE HEAVY AND TALL. MAKE SURE YOU
ARE ALWAYS WORKING SAFELY BY USING APPROPIRATE TOOLS AND
EQUIPMENT. WHEN MOVING THE UNITS AROUND USING FORKLIFT,
ALWAYS MAKE SURE THE UNITS ARE IN UPRIGHT POSITION AND MOVE
WITH SLOW SPEED AND SLOW ACCELERATIONS.
WARNING!

3.3.1 Standard packaging

Perform the following steps to unpack the UPS equipment from the standard packaging:
1.
Remove the plastic film from the UPS, by cutting it where there is the cardboard underneath (on
one edge),
2.
Remove the 4x cardboard edges carefully by paying attention that the accessory box placed on
top of the UPS does not fall down. Lower the accessory box with the help of a stool or ladder;
make sure you are safe by doing that. The std. content of the accessory box is: user manual, 2x
painted sockets, screws, 4x feet and keys.
3.
Remove the bubble-film by removing the small type pieces by hand.
4.
Disassemble the front and back fixing bars (see Figure 3, right inside here below as well as Figure
4 on the next page) by unscrewing 8x M8 hexagonal screws.
5.
Mount the 4x adjustable feet (feet are in the accessory box) as shown in Figure 5 on the next page.
6.
After having placed the UPS in its final position, disassemble the left and right socket as shown in
Figure 6 on the next page and mount the front and back painted sockets.
7.
You may want to keep some packaging materials for later use. Alternatively, in case in makes more
sense to dispose the packing material, it must be disposed in accordance with the applicable laws
in the country where the UPS is installed.
1)
Figure 3: Photographs of PowerWave 33 S3 being unpacked step-by-step.
Modifications reserved
Page 10/50
2) 3)