General Characteristics; Environmental Requirements; Ce Marking And Declaration Of Safety And Emc Conformity; Inquiries - ABB PowerWave 33 Series 3 User Manual

2 General characteristics

2.1 Environmental requirements

THIS IS A PRODUCT FOR COMMERCIAL AND INDUSTRIAL APPLICATION
IN THE SECOND ENVIRONMENT – INSTALLATION RESTRICTIONS OR
ADDITIONAL MEASURES MAY BE NEEDED TO PREVENT DISTURBANCES.
WARNING!
To operate the UPS at the best efficiency point, your installation site should meet the environmental
parameters outlined in this manual. Excessive amount of dust or moisture in the operating environment
may cause damage or lead to malfunction. The UPS should be always protected from the outside
weather and sunshine. The operating environment must meet the weight, airflow, size and clearance
requirements specified in the section 4.1 of this manual or in the technical datasheet (TDS) of the same
product (separate document).
Under no circumstances, the UPS should be installed in an airtight room, in the presence of flammable
gases, or in an environment, exceeding environmental requirements specified here below.
The ambient temperature for operating the UPS must be in the range 0 °C to +40 °C. The Ideal
temperature also recommended to achieve a long life of the UPS and VRLA batteries is +20°C to +25°C.
The relative humidity should be below 95% (non-condensing) and the max. altitude without de-rating is
1000m above sea level.

2.2 CE marking and declaration of safety and emc conformity

The product has the CE marking in compliance with the following European directives
•
Low Voltage Directive:
•
EMC Directive:
The product applies the actual UPS standards, listed in the Table 1 below.
Table 1: UPS Standards.
Description
Safety
Electromagnetic Compatibility (EMC)
Performance
Environmental aspects

2.3 Inquiries

Address inquiries about the UPS to the local office or agent CERTIFIED by the supplier. Please note the
type code and the serial number – shown in the type plate of the product (see section 2.4) – of the
equipment and contact your nearest agent CERTIFIED by the supplier.
Modifications reserved
Page 7/50
2006/95/EC
2004/108/EC
Product standards
IEC/EN 62040-1
IEC/EN 62040-2
Emission cat. C3
Immunity cat. C3
IEC/EN 62040-3
IEC/EN 62040-4
General standards
IEC/EN 60950-1
IEC/EN 61000-4-2
IEC/EN 61000-4-3
IEC/EN 61000-4-4
IEC/EN 61000-4-5
IEC/EN 61000-4-6
IEC/EN 61000-4-8
IEC/EN 61000-2-2