Decal Installation - Hangar 9 P-51D Mustang 20cc Instruction Manual

205. Attach the drop tanks to the drop tank mounts using two M4
x 12 socket head cap screws and two M4 lock washers. Use
a 3mm hex wrench to tighten the screws.
 Remove the drop tanks for transport
to avoid damage to them.
206. Use a hobby knife to remove the covering from the leading
edge of the wing for the gun mounts.
207. Insert the rounded ends of the guns into the holes in
the loading edge of the wing. The depth of each gun is
determined by the structure installed inside the wing. Check
to make sure each gun is parallel as shown. Use 15-minute
epoxy to glue the guns into position.
 Small adjustments can be made by moving them
slightly. If larger adjustments are necessary, the holes
may require enlargement carefully using a drill bit.
 DECAL INSTALLATION
208. Apply the decals to your model using the box art from your
model as a guide to location. Use a spray bottle and a drop of
dish washing liquid or glass cleaner sprayed in the location
of the decal to allow repositioning of the decal. Use a paper
towel as a squeegee to remove excess water from under the
decal. Allow the model to rest overnight so the remaining
water can evaporate.
EN 32