157569-1CD
MPL100
9.3.3 Grease Replenishment/Exchange for U-Axis Speed Reducer
Fig. 9-6: U-Axis Speed Reducer Diagram
9.3.3.1 Grease Replenishment
9
Maintenance and Inspection
9.3 Notes on Grease Replenishment/Exchange Procedures
Grease exhaust port
Hexagon socket head plug
(Refer to Fig. 9-6 "U-Axis Speed Reducer Diagram".)
1. Remove the hexagon socket head plugs from the grease inlet and
grease exhaust port.
• If grease is injected with the plug on, grease will leak
inside the motor and may cause a damage. Make sure to
remove the plug before the grease injection.
NOTE
• Do not install a joint, a hose, etc. to the grease exhaust
port. Failure to observe this instruction may result in
damage to the motor due to coming off of an oil seal.
2. Install a grease zerk A-PT1/8 to the grease inlet.
(The grease zerk is delivered with the manipulator.)
3. Inject grease through the grease inlet using a grease gun
– Grease type:
– Amount of grease:
– Air supply pressure of grease pump:
– Grease injection rate:
4. Move the U-axis for a few minutes to discharge excess grease.
9-16
Grease inlet
U-axis speed
Hexagon socket head plug
reducer
Molywhite RE No.00
320 cc
(640 cc for 1st supply)
0.3 MPa or less
8 g/s or less
HW0485652
81 of 106