Bosch MUC24 Series Instruction Manual page 6

en Control panel
Controls
X Fig. B
B Standby
Switches the appliance standby
mode on or off.
A Set the start time delay
The start time delay can be set for
the selected preparation programme.
Select a preparation programme
D
from the list (g)
The individual preparation
programmes are displayed one
after another by repeatedly pressing
button D. The corresponding LED
lights up in the control panel.
C Set a customised preparation
temperature
For customised adjustment of the
preparation temperature.
E Adjust the preparation time
The pre-configured preparation
time [medium] for a preparation
programme can be shortened
[short] or lengthened [long]. The
corresponding indicator (f) lights up.
The corresponding pre-configured
preparation time is shown in the
display (a).
F Set a customised preparation time
For customised adjustment of the
preparation time.
G Confirm the programme
Pressing button G starts the
selected preparation programme.
Delete a setting or abort the
H
programme
Pressing button H deletes the
settings or stops a programme that
was previously started.
6
MUC2_MUC4_EU2.indb 6
Indicators
X Fig. C
a Display
Display of the remaining time or the
temperature.
b timer
Indicates that the start time delay is
enabled. The display (a) shows the time
until the start of the selected preparation
programme.
c Preparation steps / programme
progress
Display of the individual preparation
steps and the programme progress. In
the case of multiple preparation steps
(e.g. the ingredients are added after
heating the deep frying oil), these are
visually indicated by the illumination of
LEDs 1, 2, 3 or 4. An audible signal also
sounds if a subsequent preparation step
is required.
d finished
This indicates that the meal is ready.
The display (a) flashes and shows
"00:00". An audible signal also sounds.
e keep warm
Indicates that the keep warm function is
switched on at the end of a preparation
programme. A rectangle lights up in the
display (dotted line).
f Display of the pre-configured
preparation time
The pre-configured preparation
time [medium] for a preparation
programme can be shortened [short] or
lengthened [long] using button E. The
corresponding indicator lights up.
g List of preparation programmes
There are 16 pre-configured preparation
programmes available. The individual
preparation programmes are displayed
one after another by repeatedly pressing
button D. The corresponding LED lights
up in the control panel.
h recipe 1&2 (depending on model)
Memory locations for preparation
programmes with customised time and
temperature.
15.03.2016 12:58:24