Spreading With Automatic Operating Mode (Auto Km/H + Auto Kg) - Rauch QUANTRON-A AXIS-M 20 Q Instruction Manual

5 Spreading operation with the QUANTRON-A control unit
5.3

Spreading with automatic operating mode (AUTO km/h + AUTO kg)

Mass flow control with the M EMC function
Mass flow is measured separately on both spreading disc sides. Thus deviations
to the specified application rate can be immediately corrected.
The M EMC function requires the following machine data for mass flow control:
PTO speed

Spreading disc type

A PTO speed between 450 and 650 rpm is possible.
The desired speed should remain constant during spreading (+/- 10 rpm).

High control quality can therefore be ensured.
The idle measurement is only possible if the actual PTO speed deviates by

max. +/- 10 rpm from the entry in the PTO menu. Outside of this range, idle
measurement is not possible.
Precondition for spreading:
The AUTO km/h + AUTO kg operating mode is active (refer to

TO/MAN mode, page
1. Fill the hopper with fertiliser.
2. Adjust fertiliser settings:


3. Enter the PTO speed in the corresponding menu.
See also "PTO shaft" on page
4. Select the spreading disc type used in the corresponding menu.
See also "Spreading disc type" on page
5. Switch on PTO shaft.
6. Set PTO shaft to the PTO speed entered.
 The Idle measurement screen is displayed.
Set spreading speed
Current joint shaft speed
Figure 5.3:
7. Wait until the progress bar has entirely passed through.
 Idle measurement is finished.
 Idle time is reset to 20 min.
90
58).
Application rate (kg/ha)
Working width (m)
Idle measurement
Idle measurement
required!
Set spreading speed,
maintain constant.
Idle measurement information screen
-49.
-49.
4.7.2: AU-