Quantity; Signal For Empty Run Measurement - Rauch QUANTRON-A AXIS-M 20 Q Instruction Manual

4.7.3

+/- Quantity

In this menu, an Application rate adjustment percentage for standard spread-
ing can be specified.
The preset value of the metering slider opening serves as basis (100%).
During operation, you can use the F2/F3 function keys to change the application
rate by the factor of +/- quantity at any time.
The pre-configuration can be restored with the C 100% key.
Defining the quantity reduction:
1. Open the Machine settings > +/- Quantity (%) menu.
2. Enter the percentage by which the spreading quantity is to be adjusted.
See chapter
3. Press the Enter key.
4.7.4

Signal for empty run measurement

Here you can activate or deactivate the signal tone for the accomplishment of the
empty run measurement.
1. Highlight the empty run measurement menu item.
2. Activate the option by pressing the Enter key.
 The display shows a tick.
 There is an acoustic signal for each start of an automatic idle measure-
3. Deactivate the option by pressing the Enter key once more.
 The tick disappears.
4.13.2: Entering values with the cursor keys, page
ment.
Operation QUANTRON-A
NOTICE
4
84.
61